Project Description

BRASS GAS ANGLE BALL COCKS

BRASS GAS ANGLE BALL COCKS

AVAILABLE MODELS
180: Angle, FxF
181: Angle, MxF
182: Angle, MxM
183: Angle, 1/2″ M  x swivel nut
184: Angle, 1/2″ F x swivel nut

INSTALLATION

Ball valves are bi-directional, they could handle the flow in both directions.
To install a ball valve correctly:

  1. Make sure that the pipes are well aligne;
  2. Do not exceed in using sealing materials such as (PTFE or other material), use it only on the thread.

MAINTENANCE
It is important to verify the valves periodically to make sure that the valve is in good working conditions. The valve is supplied at opening position.
The opening and the closing are made by a 90° rotation of the handle. In the opening position, the handle is along the body of the valve, while in the closing position the handle is across the body. The ball valve is an interception valve and not a regulation one, therefore it must be completely opened or closed; if left at an intermediate position, seals could be damaged.
Only if you have to empty the pipe system, to prevent from frost problems, the valve must be opened at an intermediate position (45°) up to the complete discharge of the liquid, after that the valve could be fully opened.
It is suggested not to use the valve for liquids with abrasive suspensions.

DISPOSAL
For valve operating with hazardous liquids (toxic, corrosive…) , if there is a possibility of residue remaining in the valve, take due safety precaution and carry out required cleaning operation. Personnel in charge must be trained and equipped with appropriate protection devices. Prior to disposal, disassemble the valve and separate the component according to various materials. Please refer to product literature for more information. Forward sorted material to recycling (e.g. metallic materials) or dispose it, according to local and currently valid legislation taking into consideration the environment.