Project Description

BRASS WATERMETER TWO-WAY PLUG COCK
MXM, PN10

BRASS WATERMETER TWO-WAY PLUG COCK MXM, PN10

AVAILABLE MODELS
506: For water meter, brass, lockable, MxM

Please refer to single item for available measures.

INSTALLATION
For the sealing on threads, use material compatible with the fluid used only. Ensure that threads are prepared correctly to provide a good and long lasting service.
Valves should not be over tightened with a wrench. Ensure the male thread is the correct type and length. If the thread is too short a leak may occur. If the thread is too long then damage may be made to the valve. Ensure that good quality tools are used to provide an accurate joint and therefore avoiding the risk of leaking. Thread tape may be used and applied to the external of the male thread after the threads have been cleaned.

The following should be avoided:
• Careless handling of the valve;
• Excessive force during assembly.

JOINING THE VALVE AND PIPE
Fix the threaded pipe into a vice and then turn the valve on to the pipe.
A close fitting spanner should be applied to the valve hexagon flats being fixed. By tightening the valve onto the pipe in this way, the valve avoids being distorted with the consequential damage to internal parts.

MAINTENANCE
No maintenance required.

DISPOSAL
Prior to disposal, disassemble the valve and separate the component according to various materials. Please refer to product literature for more information. Forward sorted material to recycling (e.g. metallic materials) or dispose it, according to local and currently valid legislation taking into consideration the
environment.

GENERAL INFORMATION
Performance data, including pressure – temperature ratings have been developed from published standards, supplier material certifications, design calculations and in-house testing. They cover typical applications and are provided as a general guideline.