Project Description

BRASS “Y” PATTERN STRAINERS

liquids or aeriforms

BRASS "Y" PATTERN STRAINERS for liquids and aeriforms

Brass “Y” pattern strainers for liquids PN20 available in thefollowing versions :with MINI drain valve, reducing bore, lockable cap.

FILTERING CARTRIDGE STAINLESS STEEL AISI 304: liquids
1/4″ – 1″  400μm
1″ ¼ – 2” 500μm
2″ ½ – 3” 600μm
4″           1.00μm

For aeriforms PN16:

FILTERING CARTRIDGE STAINLESS STEEL AISI 304: aeriforms
1/4″ – 2″  200 μm

Maximum working temperatures: 80°C, in absence of steam.
Available in different versions and measures.
Threads: ISO228 FxF
Brass plug
Finishing sandblast

APPLICATIONS AND USES
“Y” pattern strainers are typically used in applications where the amount of solids to be removed is small, and where frequent clean-out is not required. Rastelli “Y” pattern strainer are suitable for water systems, for low temperature hot water systems.

INSTALLATION AND MAINTENANCE
It is suggested to install the “Y” strainer following the arrow marked on the body and with the cap facing down, so that when it is opened, all the collected impurities on the straining component, will go out and they will not go back inside the pipe. Before installing the “Y” strainer, it is advisable to check if there is enough space to take out the straining components. After the cleaning of the strainer, check carefully the cap seal and if you have doubts, do not hesitate to replace it. When a new plant is put on work, after few hours of working, it is advisable to open all installed strainers to clean out the typical residues of new pipes.

DISPOSAL
For valve operating with hazardous liquids (toxic, corrosive…) , if there is a possibility of residue remaining in the valve, take due safety precaution and carry out required cleaning operation. Personnel in charge must be trained and equipped with appropriate protection devices. Prior to disposal, disassemble the valve and separate the component according to various materials. Please refer to product literature for more information. Forward sorted material to recycling (e.g. metallic materials) or dispose it, according to local and currently valid legislation taking into consideration the environment.

GENERAL INFORMATION
Performance data, including pressure – temperature ratings have been developed from published standards, supplier material certifications, design calculations and in-house testing. They cover typical applications and are provided as a general guideline.